Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated): Procedure

1. Reset the power window regulator motor for the power window that does not fully close. Refer to INITIALIZATION .
2. Check if the window AUTO UP/DOWN function operates normally.

   OK

   AUTO UP/DOWN function operates normally.

OK → END 

NG: Go to next step 

1. Remove the door glass. Refer to COMPONENTS .
2. Operate the power window regulator without installing the door glass using the power window switch.
3. Check that the power window regulator operates smoothly.

   OK

   Power window regulator operates smoothly.

NG → REPLACE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (LH AND RH) 

OK → REPLACE DOOR GLASS RUN (LH AND RH)