Rear Speed Sensor: Installation: Installation
- INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (REAR SPEED SENSOR)
- Install the rear axle hub and bearing onto the axle beam with the 4 bolts.
Torque: 90 N*m (918 kgf*cm, 66 ft.*lbf)
- Install the rear axle hub and bearing onto the axle beam with the 4 bolts.
- INSPECT REAR AXLE HUB BEARING . Refer to ON-VEHICLE INSPECTION - Step 3
- CONNECT SPEED SENSOR WIRE . Refer to INSTALLATION - Step 3
- INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
- ADJUST REAR DRUM BRAKE SHOE CLEARANCE . Refer to INSTALLATION - Step 2
- INSTALL REAR WHEEL
Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)
- INSPECT REAR WHEEL ALIGNMENT
Refer to INSPECTION
- CHECK VSC SENSOR SIGNAL
Refer to TEST MODE PROCEDURE