How To Proceed With Troubleshooting

HINT: 

*: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. CUSTOMER PROBLEM ANALYSIS 
   1. Interview the customer and confirm the trouble.

      NEXT: Go to next step 

3. CHECK DTC AND FREEZE FRAME DATA* 
   1. Check and record a DTC and Freeze Frame Data.
   2. Clear the DTC and Freeze Frame Data. Refer to DTC CHECK / CLEAR  for DTC Check/Clear, or FREEZE FRAME DATA  for Freeze Frame Data).
   3. Reconfirm the DTC.
      1. Reconfirm the DTC based on the recorded DTC and Freeze Frame Data. Refer to DTC CHECK / CLEAR  for DTC Check/Clear, or FREEZE FRAME DATA  for Freeze Frame Data).

         HINT: 

         If any of the DTCs U0100/65, U0123/62, U0124/95, and U0126/63 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit. Refer to CHECK FOR INTERMITTENT PROBLEMS .

         Result

         Result	Proceed to
         DTC output	A
         DTC not output (Problem symptom does not occur)	B
         DTC not output (Problem symptom occurs)	C

      B → GO TO STEP 5   5 

      C → GO TO STEP 6   6 

      A: Go to next step 

4. DIAGNOSTIC TROUBLE CODE CHART 
   1. Proceed to Diagnostic Trouble Code Chart. Refer to DIAGNOSTIC TROUBLE CODE CHART .

      NEXT → GO TO STEP 7  7 

5. SYMPTOM SIMULATION 
   1. Proceed to Check for Intermittent Problems. Refer to CHECK FOR INTERMITTENT PROBLEMS .

      NEXT: Go to next step 

6. PROBLEM SYMPTOMS TABLE 
   1. Proceed to Problem Symptoms Table. Refer to PROBLEM SYMPTOMS TABLE .

      NEXT: Go to next step 

7. CIRCUIT INSPECTION* 

   NEXT: Go to next step 

8. IDENTIFICATION OF PROBLEM 

   NEXT: Go to next step 

9. REPAIR OR REPLACEMENT 

   NEXT: Go to next step 

10. CONFIRMATION TEST* 

    NEXT → END