Key Luggage Compartment Lock-in Prevention Function does not Operate: Procedure

1. Check that the entry luggage compartment open function operates. Refer to OPERATION CHECK [05/2013 - ] .

   Result

   Result	Proceed to
   Entry luggage compartment door open function operates	A
   Entry luggage compartment door open function does not operate	B

B → See step   8 

A: Go to next step 

1. Bring the electrical key transmitter sub-assembly near the No. 3 indoor electrical key oscillator (inside luggage), and check that the entry luggage compartment lock-in prevention function operates.
   Fig 1: Identifying Inspection Point

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   TEXT IN ILLUSTRATION
   
   

   *a	Inspection Point

   NOTE:

   If the electrical key transmitter sub-assembly is brought within 0.2 m (0.656 ft.) of the No. 3 indoor electrical key oscillator (inside luggage), communication is not possible.

   HINT: 

   • When the electrical key transmitter sub-assembly is brought near the No. 3 indoor electrical key oscillator (inside luggage), the possibility of wave interference decreases, and it can be determined if wave interference is causing the problem symptom.
   • If the operation check is normal, the possibility of wave interference is high. Also, added vehicle components may cause wave interference. If installed, remove them and perform the operation check.

   OK

   Entry functions operate normally.

NG → See step   3 

OK → AFFECTED BY WAVE INTERFERENCE 

1. Check the following antennas in the key diagnostic mode. Refer to OPERATION CHECK [05/2013 - ] .
   Fig 2: Identifying Inspection Point

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   TEXT IN ILLUSTRATION
   
   

   *a	Inspection Point

2. When the electrical key transmitter sub-assembly is held at the same height as the rear bumper upper surface and aligned with the center of the rear of the vehicle, check that the wireless door lock buzzer sounds.

   HINT: 

   • Place the key in the luggage area.
   • If the buzzer sounds, it can be determined that the No. 3 indoor electrical key oscillator (inside luggage compartment) is operating normally.

   OK

   Wireless door lock buzzer sounds.

NG → See step   4 

OK → See step   9 

1. Disconnect the D40 certification ECU (smart key ECU assembly) connector.
2. Disconnect the H9 No. 3 indoor electrical key oscillator (inside luggage) connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   D40-9 (CLG7) - H9-1 (ANTE7)	Always	Below 1 Ω
   D40-8 (CG7B) - H9-3 (CLGB)	Always	Below 1 Ω
   D40-9 (CLG7) or H9-1 (ANTE7) - Body ground	Always	10 kΩ or higher
   D40-8 (CG7B) or H9-3 (CLGB) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Connect the D40 certification ECU (smart key ECU assembly) connector.
2. Disconnect the H9 No. 3 indoor electrical key oscillator (inside luggage) connector.
3. Measure the voltage according to the value(s) in the table below.
   Fig 3: Checking Certification ECU (Smart Key ECU Assembly) With Waveform

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK

   Tester Connection	Switch Condition	Tool Setting	Specified Condition
   H9-1 (ANTE7) - H9-3 (CLGB)	Procedure: Engine switch off Electrical key transmitter sub-assembly not inside vehicle All doors closed Driver door lock sensor not touched → touched	2 V/DIV., 500 ms/DIV.	Pulse generation (See waveform)

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to No. 3 Indoor Electrical Key Oscillator (Inside Luggage Compartment))
   *b	Waveform
   *c	Driver side door lock sensor not touched
   *d	Driver side door lock sensor touched

NG → See step   9 

OK: Go to next step 

1. Replace the No. 3 indoor electrical key oscillator (inside luggage). Refer to REMOVAL [05/2013 - ] .

NEXT: Go to next step 

1. Check that the entry luggage compartment lock-in prevention function operates normally. Refer to OPERATION CHECK [05/2013 - ] .

   OK

   Entry luggage compartment lock-in prevention function operates normally.

NG → See step   9 

OK → END (NO. 3 INDOOR ELECTRICAL KEY OSCILLATOR WAS DEFECTIVE)