LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Scion >> 2013 >> FR-S Standard Trans >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Occupant Classification System (Diagnostics - Introduction) >> Occupant Classification System >> Data List/Active Test [03/2012 - ] >> Data List/Active Test [03/2012 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List/Active Test [03/2012 - ]

  1. DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
    1. Turn the ignition switch off.
    2. Connect the Techstream to the DLC3.
    3. Turn the ignition switch to ON.
    4. Turn the Techstream on.
    5. Enter the following menus: Body Electrical/Occupant Detection/Data List.
    6. Check the values by referring to the table below.
      OCCUPANT DETECTION

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Passenger Detection Passenger detection status/
      ON/OFF      		 ON/OFF -
      Status of Passenger Side Buckle SW Passenger side buckle switch/
      Set/Unset/NG      		 Set/Unset -
      Number of Present DTC Number of present DTC recorded/
      Min.: 0, Max.: 255      		 0 -
scientia non olet · About LEMON Manuals