DTC P0365: Camshaft Position Sensor "B" Circuit (Bank 1); DTC P0367: Camshaft Position Sensor "B" Circuit Low Input (Bank 1); DTC P0368: Camshaft Position Sensor "B" Circuit High Input (Bank 1): Procedure

1. Disconnect the camshaft position sensor for exhaust side connector.
   Fig 1: Checking Camshaft Position Sensor Power Source

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   B23-3 (VC2) - Body ground	Ignition switch ON	4.5 to 5.0 V

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Camshaft Position Sensor for Exhaust Side)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Disconnect the camshaft position sensor for exhaust side connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   B23-1 (VVE+) - B30-75 (EV1+)	Always	Below 1 Ω
   B23-2 (VVE-) - B30-121 (EV1-)	Always	Below 1 Ω
   B23-1 (VVE+) or B30-75 (EV1+) - Body ground	Always	10 kΩ or higher
   B23-2 (VVE-) or B30-121 (EV1-) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Check the camshaft position sensor for exhaust side installation.
   Fig 2: Identifying Proper Installation Position Of Camshaft Position Sensor

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   OK

   Sensor is installed correctly.

NG → See step   7 

OK: Go to next step 

1. Check the teeth of the No. 2 camshaft.

   OK

   Teeth do not have any cracks or deformation.

NG → See step   8 

OK: Go to next step 

1. Replace the camshaft position sensor for exhaust side. Refer to REMOVAL .

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs. Refer to DTC CHECK / CLEAR .
5. Start the engine and idle it for 10 seconds or more.
6. Enter the following menus: Powertrain / Engine / Trouble Codes / Pending.
7. Read the DTCs.
   RESULT
   
   

   Result	Proceed to
   No DTC is output	A
   P0365, P0367 or P0368 is output	B

   HINT: 

   If the engine does not start, replace the ECM.

B → See step   9 

A → END