Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch [06/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / D-Door Motor / Data List.
5. Read the Data List according to the display on the Techstream.

   Body Electrical > D-Door Motor > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   D Door P/W Auto SW	Driver door power window auto switch signal	OFF or ON	OFF: Driver door power window auto switch not being operated ON: Driver door power window auto switch being operated	-

   Body Electrical > D-Door Motor > Data List 

   Tester Display
   D Door P/W Auto SW

   OK

   On the Techstream screen, ON or OFF is displayed accordingly.

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

See step  4

Result:  1

OK 

See step  2

1. Initialize the power window regulator motor assembly (for driver door).

   Refer to INITIALIZATION [06/2015 - ]

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  3

1. Check that the driver door power window moves when the auto up and down function of the power window regulator master switch assembly is operated.

   Refer to OPERATION CHECK [06/2015 - ]

   OK

   Driver door auto up and down function is normal.

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result:  2

NG 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR). Refer to  REMOVAL [06/2015 - ] 

1. Remove the power window regulator master switch assembly.

   Refer to REMOVAL [06/2015 - ]

2. Inspect the power window regulator master switch assembly.

   Refer to INSPECTION [06/2015 - ]

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY. Refer to  REMOVAL [06/2015 - ] 

Result:  1

OK 

See step  5

1. Disconnect the I7 power window regulator motor assembly (for driver door) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I4-4 (A) - I7-4 (AUTO)	Always	Below 1 Ω
   I4-4 (A) or I7-4 (AUTO) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR). Refer to  REMOVAL [06/2015 - ] 

Result:  2

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR