DTC B1796: Sleep Operation Failure of Occupant Classification ECU [06/2015 - ]: Procedure

1. Turn the ignition switch off.
2. Disconnect the cable from the negative (-) battery terminal.
3. Replace the occupant detection ECU.

   Refer to REMOVAL [06/2015 - ]

4. Connect the cable to the negative (-) battery terminal.

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  2

1. Using the Techstream, perform zero point calibration and sensitivity check.

   Refer to INITIALIZATION [06/2015 - ]

   Body Electrical > Occupant Detection > Utility 

   Tester Display
   Zero Point Calibration & Sensitivity Check

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

END