DTC P060B: Internal Control Module A/D Processing Performance [05/2014 - ]: Procedure
- CHECK FOR DTC
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Clear the DTCs. Refer to DTC CHECK / CLEAR [05/2014 - ] .
- Turn the Techstream off.
- Turn the ignition switch off.
- Disconnect the Techstream.
- Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
- Connect the cable to the negative (-) battery terminal.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON and turn the Techstream on.
- Wait 16 seconds or more.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Check for DTCs.RESULT
Result Proceed to DTC is not output A DTC P060B is output B DTC P060B and P0327 or P0328 are output C
B → See step 3
C → See step 4
A → See step 2
- CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [05/2014 - ]
- REPLACE ECM. Refer to REMOVAL [05/2014 - ]
- GO TO DTC P0327 OR P0328. Refer to DTC P0327: KNOCK SENSOR 1 CIRCUIT LOW INPUT (BANK 1 OR SINGLE SENSOR); DTC P0328: KNOCK SENSOR 1 CIRCUIT HIGH INPUT (BANK 1 OR SINGLE SENSOR) [05/2014 - ]