Specifications Index
SPECIFICATIONS INDEX - FORTWO
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service Procedures | see CLIMATE CONTROL (COUPE) | ||
| Service Specifications | see CAPACITIES & SPECIFICATIONS | ||
| Torque | see TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Torque | see WHEEL LOCATION, WHEEL HUB Tighten the screws for the hub alternately. |
||
| Battery | see TEST VALUES FOR BATTERY, VOLTAGE SUPPLY | ||
| Brakes | |||
| Bleeding Sequence | see BLEED BRAKE SYSTEM | ||
| Disc Brakes | |||
| Service Specifications | see TEST & ADJUSTMENT VALUES | ||
| Torque | see TORQUE SPECIFICATIONS | ||
| Charging | |||
| Torque | see TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | Drive Belt is self-adjusting | ||
| Drive Belt Routing | See the illustration under REMOVE/INSTALL POLY-V BELT FOR COMPRESSOR | ||
| Engine Cooling | |||
| General Service Specifications | see TEST & ADJUSTMENT VALUES | ||
| Thermostat R & I | see REMOVE/INSTALL COOLANT THERMOSTAT | ||
| Water Pump R & I | see REMOVE/INSTALL COOLANT PUMP | ||
| Engine Mechanical | |||
| Compression | see TEST COMPRESSION PRESSURE | ||
| Oil Pressure | see OIL PRESSURE | ||
| Overhaul | see ENGINE TIMING (COUPE)and CRANK ASSEMBLY (COUPE) | ||
| Torque | see TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate | |||
| Torque | Stage 1: 20 Nm Stage 2: angle-tighten an additional 90° |
||
| Fuel System | |||
| Pressure Specification | NA | ||
| Checking Fuel Pressure | see 450 589 09 21 00 PRESSURE GAUGE | ||
| Fuel Filter R & I | |||
| Fuel filter is integrated with fuel pump. | |||
| Ignition | |||
| Firing Order & Cylinder Identification | see FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Spark Plug | |||
| Bosch | P/N: YR6KI332S | ||
| Gap | .028 In. (.70 mm) | ||
| Torque | see table "SPARK PLUGS" under IGNITION SYSTEM | ||
| Starter | |||
| Torque | Starter mounting bolts: 42 Nm Battery positive cable to solenoid: 10 Nm |
||
| Wheel Alignment | |||
| Adjustment Specifications | see TEST & ADJUSTMENT VALUES | ||
| Torque | see TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel To Wheel Hub | 110 Nm |
||