Vehicle Speed Sensor: Installation
WARNING: This page is about a different car, the 2001 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Discard vehicle speed sensor and after removal, replace with a new one.
- Ensure sensor mounting hole is clean and free of foreign matter.
- Align tip end of key with key groove on end of speedometer shaft during installation.
- Hand tighten vehicle speed sensor.
- Tighten vehicle speed sensor using suitable tool.
Tightening torque: 5.9 N.m (0.6 kgf-m, 4.3 ft-lb)
- Connect connector to vehicle speed sensor.
- Install center exhaust pipe, rear exhaust pipe and muffler.