LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2001 >> Outback Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> A/T Servicing >> Removal & Installation >> Select Cable >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Select Cable: Removal

  1. Prior to removal, set lever to "N" position.
  2. Remove under cover.
    CAUTION: When removing exhaust pipes, be careful each exhaust pipe does not drop out.
  3. Remove rear exhaust pipe and muffler.
  4. Remove heat shield cover. See Figure .
  5. Remove snap pin from range select lever. See Fig 1 .
  6. Remove plate assembly from transmission case. See Fig 2 .
  7. Disconnect cable from select lever and then remove cable bracket. See Figure .
  8. Remove select from plate assembly.
Fig 1: Removing Snap Pin From Range Select Lever
G00366824Courtesy of SUBARU OF AMERICA, INC.
Fig 2: Removing Plate Assembly
G00366825Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals