LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2001 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (A/T & M/T Control Systems) >> Select Cable >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Select Cable: Removal

WARNING: This page is about a different car, the 2002 Subaru Outback and 2002 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Prior to removal, set select lever to "N" position.
  2. Remove under cover.
  3. Remove rear exhaust pipe and muffler. 2.5 L model

    Refer to REMOVAL , Rear Exhaust Pipe and REMOVAL , Muffler, 3.0 L model.

    Refer to REMOVAL , Rear Exhaust Pipe and REMOVAL , Mufflers.

  4. Remove heat shield cover.
    Fig 1: Removing Heat Shield Cover
    G02960748Courtesy of SUBARU OF AMERICA, INC.
  5. Remove snap pin from range select lever.
    Fig 2: Removing Snap Pin From Range Select Lever
    G02960749Courtesy of SUBARU OF AMERICA, INC.
  6. Remove plate assembly from transmission case.
    Fig 3: Removing Plate Assembly From Transmission Case
    G02960750Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect cable from select lever and then remove cable bracket.
    Fig 4: Removing Cable Bracket
    G02960751Courtesy of SUBARU OF AMERICA, INC.
  8. Remove select cable from plate assembly.
scientia non olet · About LEMON Manuals