LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2001 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (Abs) >> ABS Control Module and Hydraulic Control Unit (ABSCM&H/U) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

ABS Control Module and Hydraulic Control Unit (ABSCM&H/U): Installation

WARNING: This page is about a different car, the 2003 Subaru Outback, 2003 Subaru Legacy, and 2003 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install ABSCM&H/U.
    CAUTION: Confirm that the specifications of the ABSCM&H/U conforms to the vehicle specifications.
    1. Tightening torque:  18 N.m (1.8 kgf-m, 13.0 ft-lb)
  2. Install ABSCM&H/U ground terminal to bracket.
    1. Tightening torque:  32 N.m (3.3 kgf-m, 24 ft-lb)
  3. Connect brake pipes to their correct ABSCM&H/U connections.
    1. Tightening torque:  15 N.m (1.5 kgf-m, 10.8 ft-lb)
    Fig 1: Connecting Brake Pipes To Correct ABSCM&H/U Connections
    G02873153Courtesy of SUBARU OF AMERICA, INC.
  4. Using cable clip, secure ABSCM&H/U harness to bracket.
  5. Connect connector to ABSCM&H/U.
    CAUTION:
    • Be sure to remove all foreign matter from inside the connector before connecting.
    • Ensure that the ABSCM&H/U connector is securely locked.
  6. Install air intake duct.
  7. Connect ground cable to battery.
  8. Bleed air from the brake system.
scientia non olet · About LEMON Manuals