General Purpose Tools
- Be sure to tighten fasteners including nuts and bolts to the specified torque.
- Place shop jacks or safety stands at the specified points.
- Apply grease onto sliding or revolving surfaces before installation.
- Before installing O-rings or snap rings, apply a sufficient amount of grease to avoid damage and deformation.
- Before securing a part in a vise, place cushioning material such as wood blocks, aluminum plates, or shop cloths between the part and the vise.
- Before disconnecting electrical connectors, be sure to disconnect ground cable from battery.
GENERAL PURPOSE TOOLS REMARKS
| TOOL NAME | REMARKS |
|---|---|
| Circuit tester | Used for measuring resistance, voltage and ampere. |