LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2003 >> Outback Base, 4D Sedan >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control System (Diagnostics) >> Subaru Select Monitor >> Operation >> Real-Time Diagnosis
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Real-Time Diagnosis

  1. Connect select monitor.
  2. Turn ignition switch and cruise control main switch to ON.
  3. Turn Subaru Select Monitor switch to ON.
  4. On the << Main Menu >> display screen, select the {Each System Check} and press the [YES] key.
  5. On the << System Selection Menu >> display screen, select the {Cruise Control} and press the [YES] key.
  6. Press the [YES] key after displayed the information of engine type.
  7. On the << Cruise Control Diagnosis >> display screen, select the {Current Data Display & Save} and press the [YES] key.
  8. Make sure that normal indication is displayed when controls are operated as indicated below:
    • Depress/release the brake pedal. (Stop light switch and brake switch turn ON or OFF.)
    • Turn ON/OFF the "SET/COAST" switch.
    • Turn ON/OFF the "RESUME/ACCEL" switch.
    • Depress/release the clutch pedal. (MT)
    • Set the selector lever to P or N. (AT)
    NOTE:
    • For detailed operation procedure, refer to the Subaru Select Monitor  .
    • For detailed concerning diagnostic trouble codes (DTCs), refer to the List of Diagnostic Trouble Code (DTC).

    < Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC)  . >

scientia non olet · About LEMON Manuals