Diagnostic Tests: Notes
CAUTION:
Perform all resistance and voltage tests with a Digital Volt-Ohmmeter (DVOM) with minimum 10-megohm impedance, unless stated otherwise in test procedures. Ensure ignition switch is in "OFF" position when performing resistance tests.
NOTE:
Subaru Select Monitor (SSM) or OBD-II generic scan tool must be used to perform diagnostic tests. Values and procedures given in tests are based on the use of SSM scan tool. Follow scan tool manufacturer's instructions. After repair or replacement of faulty parts, clear memory and retest.
NOTE:
After repair or replacement of faulty parts, clear DTC from memory. See CLEARING DIAGNOSTIC TROUBLE CODES