DTC P0139: O2 Sensor Circuit Slow Response (Bank 1 Sensor 2)
- OUTLINE OF DIAGNOSIS
Detect the slow response of rear oxygen sensor.
Calculate the response time of the output change of the rear oxygen sensor when the A/F ratio changes from rich to lean. And carry out the diagnosis comparing the calculated response time with the threshold value.
- COMPONENT DESCRIPTION
- ENABLE CONDITION ENABLE CONDITIONS
Secondary Parameters Enable Conditions Closed loop control with rear oxygen sensor In operation - GENERAL DRIVING CYCLE
Diagnosis is performed only once when the deceleration fuel is cut from the rapid acceleration. (Pay attention to oxygen sensor voltage to calculate the diagnostic value when deciding the deceleration timing.)
- DIAGNOSTIC METHOD
When the rear oxygen sensor output voltage changes from 0.5 V (rich) to 0.15 V (lean), carry out calculation regarding the response time of the output change from 0.45 V to 0.2 V as diagnostic value. When the rear oxygen sensor output voltage does not change from 0.5 V to 0.15 V, do not carry out calculation even if the output changes from 0.45 V to 0.2 V.
- Abnormality Judgment
Judge NG when the rear oxygen sensor output change response time (diagnostic value) exceeds the threshold value.
Response time > 2 seconds (threshold value) --> Abnormal
Judge NG when all of the malfunction criteria below is completed.
Judgment Value
JUDGMENT VALUE (ABNORMALITY JUDGMENT)Malfunction Criteria Threshold Value Shortest time change from rich (450 mV oxygen output) to lean (200 mV) if voltage reduces from 500 mV to 150 mV "LESS THAN EQUAL TO" 0.43 seconds 2 seconds or more fuel shut-off in decel. Experienced After fuel shut-off 2 seconds or more Time Needed for Diagnosis: 4 seconds
Malfunction Indicator Light Illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.
- Normality Judgment
Judge OK when the rear oxygen sensor output change response time (diagnostic value) is below the threshold value.
Response time "LESS THAN EQUAL TO" 2 seconds (threshold value) --> Normal
Judge NG when the malfunction criteria below is completed.
Judgment Value
JUDGMENT VALUE (NORMALITY JUDGMENT)Malfunction Criteria Threshold Value Shortest time change "LESS THAN EQUAL TO" 0.43 seconds NOTE: Response time is calculated during the deceleration fuel cut in case of abnormal judgment. However, in order to make a normal judgment quickly, diagnosis is performed without deceleration fuel cut.
- Abnormality Judgment
- DTC CLEAR CONDITION
- When the OK idling cycle was completed 40 times in a row
- When "Clear Memory" was performed
- MALFUNCTION INDICATOR LIGHT CLEAR CONDITION
- When the OK driving cycle was completed 3 times in a row
- When "Clear Memory" was performed
- FAIL SAFE
None
- ECM OPERATION AT DTC SETTING
- Memorize the freeze frame data. (For test mode $02)
- Memorize the diagnostic value and trouble standard value. (For test mode $06)