Select Lever: Assembly

Clean all parts before assembly.
Apply grease [SUNLIGHT 2 (Part No. 003602010) or equivalent] and SUNCALL or equivalent to each parts. Refer to COMPONENT and COMPONENT .
NOTE: Do not apply SUNCALL to area except following parts.

Fig 1: Applying Grease
Courtesy of SUBARU OF AMERICA, INC.
Assembly is in the reverse order of disassembly.
NOTE:
- Refer to "COMPONENT". Refer to COMPONENT .
- Tighten the lock plate bolt uniformly. After installation, locate the base plate upside down, and then push the lock plate up. Make sure the lock plate falls by its weight when releasing it. If not, retighten the bolt.
Fig 2: Tightening Lock Plate Bolt
Courtesy of SUBARU OF AMERICA, INC.
After completion of fitting, transfer the select lever to range "P" - "1", then check whether the indicator and select lever agree, whether the pointer and position mark agree and what the operating force is.