Read Current Data For Engine. (OBD Mode)
- On the << Main Menu >> display screen, select the {Each System Check} and press the [YES] key.
- On the << System Selection Menu >> display screen, select the {Engine Control System} and press the [YES] key.
- Press the [YES] key after the information of engine type is displayed.
- On the << Engine Diagnosis >> display screen, select the {OBD System} and press the [YES] key.
- On the << OBD Menu >> display screen, select the {Current Data Display & Save} and press the [YES] key.
- On the << Data Display Menu >> display screen, select the {Data Display} and press the [YES] key.
- Using the scroll key, move the display screen up or down until desired data is shown.
- A list of the support data is shown in ENGINE SUPPORT DATA SPECIFICATION (OBD MODE) .
ENGINE SUPPORT DATA SPECIFICATION (OBD MODE)
| Contents | Display | Unit of measure |
|---|---|---|
| Number of DTC | Number of DTC | - |
| Malfunction indicator light status | MI (MIL) | ON or OFF |
| Monitoring test of misfire | Misfire monitoring | Complete or incomplete |
| Monitoring test of fuel system | Fuel system monitoring | Complete or incomplete |
| Monitoring test of comprehensive component | Component monitoring | Complete or incomplete |
| Test of catalyst | Catalyst Diagnosis | Complete or incomplete |
| Test of heated catalyst | Heated catalyst | No support |
| Test of evaporative emission purge control system | Evaporative purge system | Complete or incomplete |
| Test of secondary air system | Secondary air system | No support |
| Test of air conditioning system refrigerant | A/C system refrigerant | No support |
| Test of oxygen sensor | Oxygen sensor | Complete or incomplete |
| Test of oxygen sensor heater | O2 Heater Diagnosis | Complete or incomplete |
| Test of EGR system | EGR system | No support |
| Air fuel ratio control system for bank 1 | Fuel System for Bank 1 | - |
| Engine load data | Calculated load value | % |
| Engine coolant temperature signal | Coolant Temp. | °C or °F |
| Short term fuel trim by front oxygen (A/F) sensor | Short term fuel trim B1 | % |
| Long term fuel trim by front oxygen (A/F) sensor | Long term fuel trim B1 | % |
| Intake manifold absolute pressure signal | Mani. Absolute Pressure | mmHg or kPa or inHg or psi |
| Engine speed signal | Engine Speed | rpm |
| Vehicle speed signal | Vehicle Speed | km/h or MPH |
| Ignition timing advance for #1 cylinder | Ignition timing adv. #1 | ° |
| Intake air temperature signal | Intake Air Temp. | °C or °F |
| Intake air amount | Mass Air Flow | g/s |
| Throttle position signal | Throttle Opening Angle | % |
| Oxygen sensor #11 | Oxygen Sensor #11 | - |
| Oxygen sensor #12 | Oxygen Sensor #12 | - |
| Rear oxygen sensor output signal | Oxygen Sensor #12 | V |
| Air fuel ratio correction by rear oxygen sensor | Short term fuel trim #12 | % |
| On-board diagnostic system | OBD System | CARB-OBD2 |
| A/F sensor output signal | A/F sensor #11 | V |
| A/F lambda signal | A/F sensor #11 | - |
| A/F lambda signal #11 | A/F sensor #11 | - |
| A/F sensor current #11 | A/F sensor #11 | mA |
NOTE:
For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL" .