Clear Memory Mode

Clear the DTC stored in the airbag control module after repairing the airbag system and occupant detection system. (After the breakdown is recovered, the breakdown code for completed recoveries are read out when the next breakdown occurs if the memory clear work is not performed.)

1. On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
2. On the «System Selection Menu» display screen, select the {Airbag System} and press the [YES] key.
3. On the {Airbag System} menu screen, select the {Clear Memory} and press the [YES] key.
4. When the "Clear Memory?" is shown on the screen, press the [YES] key.
5. When Done is displayed, turn the Subaru Select Monitor and the ignition switch OFF.
   NOTE: For details concerning the operation procedures, refer to the "Subaru Select Monitor Operation Manual".