LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2006 >> Outback XT, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H4DOTC) >> Subaru Select Monitor >> Operation >> How To Use The SUBARU Select Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

How To Use The SUBARU Select Monitor

  1. Prepare the Subaru Select Monitor kit. < Ref. to PREPARATION TOOL , General Description. >
    Fig 1: Identifying Subaru Select Monitor Kit
    G04998013
  2. Connect the diagnosis cable to the Subaru Select Monitor.
  3. Insert the cartridge to the Subaru Select Monitor. < Ref. to PREPARATION TOOL , General Description. >
    Fig 2: Inserting Cartridge Into Subaru Select Monitor
    G04998014
  4. Connect the Subaru Select Monitor to the data link connector.
    1. Data link connector is located in the lower portion of instrument panel (on the driver's side).
      Fig 3: Locating Data Link Connector
      G05017015
    2. Connect the diagnosis cable to the data link connector.
    CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
  5. Turn the ignition switch to ON (engine OFF) and Subaru Select Monitor switch to ON.
    Fig 4: Identifying Subaru Select Monitor Switch
    G05021598
  6. Using the Subaru Select Monitor, call up DTC and data, then record them.
scientia non olet · About LEMON Manuals