Cruise Control Command Switch: Removal

WARNING: This page is about a different car, the 2006 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Before servicing, be sure to read the notes in the AB section for proper handling of the driver's airbag module. < Ref. to CAUTION , GENERAL DESCRIPTION. >

Set front wheels in straight ahead position.
Turn ignition switch OFF.
Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
Using TORX® BIT T30 (Tamper resistant type), loosen two TORX® bolts which secure driver's air-bag module.

Fig 1: Loosening Torx® Bolt
Courtesy of SUBARU OF AMERICA, INC.
Disconnect airbag module connector on back of airbag module.
Remove horn switch from steering wheel as shown.

Fig 2: Locating Horn Switch From Steering Wheel
Courtesy of SUBARU OF AMERICA, INC.
Disconnect horn and cruise control command switch connector, then remove cruise control command switch.

Fig 3: Identifying Cruise Control Command Switch Connector
Courtesy of SUBARU OF AMERICA, INC.