Led Operation Mode For Engine
- On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
- On the «System Selection Menu» display screen, select the {Engine Control System} and press the [YES] key.
- Press the [YES] key after the information of engine type has been displayed.
- On the «Engine Diagnosis» display screen, select the {Current Data Display/Save}, and then press the [YES] key.
- On the «Data Display» screen, select the {Data LED Display} and press the [YES] key.
- Using the scroll key, scroll the display screen up or down until the desired data is shown.
A list of the support data is shown in the following table.
SUPPORT DATA
| Remarks | Display | Message | LED "ON" requirements |
|---|---|---|---|
| AT/MT identification signal | AT Vehicle ID Signal | ON or OFF | Illuminate (AT model) |
| Test mode signal | Test Mode Terminal | U check or D check | D check |
| Neutral position switch signal | Neutral Position Switch | ON or OFF | When neutral position signal is input. |
| Idle switch signal | Idle Switch Signal | ON or OFF | When idle switch signal is input. |
| Ignition switch signal | Ignition Switch | ON or OFF | When ignition switch is turned ON. |
| Power steering switch signal | P/S Switch | ON or OFF | When power steering switch is entered. |
| Air conditioning switch signal | A/C Switch | ON or OFF | When air conditioning switch is input. |
| Starter switch signal | Starter Switch | ON or OFF | When starter switch is input. |
| Rear oxygen sensor rich signal | Rear O2 Rich Signal | Rich or Lean | When rear oxygen sensor mixture ratio is rich. |
| Knocking signal | Knocking Signal | Provided or None | When knocking signal is input. |
| Crankshaft position sensor signal | Crankshaft Position Signal | Provided or None | When crankshaft position sensor signal is input. |
| Camshaft position sensor signal | Camshaft Position Signal | Provided or None | When camshaft position sensor signal is input. |
| Rear defogger switch signal | Rear Defogger Switch | ON or OFF | When rear defogger switch is turned to ON. |
| Blower fan switch signal | Blower Fan Switch | ON or OFF | When blower fan switch is turned to ON. |
| Light switch signal | Light Switch | ON or OFF | When light switch is turned ON. |
| A/C middle pressure switch signal | A/C Mid Pressure Switch | ON or OFF | When A/C middle pressure switch is turned to ON. |
| Air conditioning relay signal | A/C Compressor Signal | ON or OFF | When air conditioning relay is in function. |
| Radiator fan relay 1 signal | Radiator Fan Relay #1 | ON or OFF | When radiator fan relay 1 is in function. |
| Radiator fan relay 2 signal | Radiator Fan Relay #2 | ON or OFF | When radiator fan relay 2 is in function. |
| Fuel pump relay signal | Fuel Pump Relay | ON output or OFF output | ON output |
| PCV hose assembly diagnosis signal | Blow-by Leak Connector | Connected or Not connected | PVC hose assembly connected |
| Pressure control solenoid valve signal | PCV Solenoid Valve | ON or OFF | Pressure control solenoid valve is operated. |
| Drain valve signal | Vent Control Solenoid | ON or OFF | Drain valve is operated. |
| Variable valve lift diagnosis oil pressure switch signal 1 | Oil Press. SW1 | ON or OFF | When variable valve lift diagnosis oil pressure switch signal 1 is ON. |
| Variable valve lift diagnosis oil pressure switch signal 2 | Oil Press. SW2 | ON or OFF | When variable valve lift diagnosis oil pressure switch signal 2 is ON. |
| AT retard angle demand signal | Retard Signal | Provided or None | When AT retard angle demand signal is input. |
| AT fuel cut signal | Fuel Cut | Provided or None | When AT fuel cut signal is input. |
| AT cooperative permission signal | Torque Control Permission | ON or OFF | When AT coordinate permission signal is input. |
| Electronic throttle control motor relay signal | ETC Motor Relay | ON or OFF | When electronic throttle control motor relay is in function. |
| Clutch switch signal | Clutch switch | ON or OFF | When clutch switch is turned to ON. |
| Stop light switch signal | Stop Light Switch | ON or OFF | When stop light switch is turned ON. |
| SET/COAST switch signal | SET/COAST Switch | ON or OFF | When SET/COAST switch is turned to ON. |
| RES/ACC switch signal | RESUME/ACCEL Switch | ON or OFF | When RES/ACC switch is turned to ON. |
| Brake switch signal | Brake Switch | ON or OFF | When brake switch is turned to ON. |
| Main switch signal | Main Switch | ON or OFF | When main switch is turned to ON. |
| Cancel switch signal | Cancel Switch | ON or OFF | When cancel switch is turned to ON. |
NOTE:
For detailed operation procedure, refer to the "Subaru Select Monitor Operation Manual".