Check Door Lock Actuator And Circuit
WARNING: This page is about a different car, the 2006 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
DOOR LOCK ACTUATOR REFERENCE CHART
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK OUTPUT SIGNAL. Measure the voltage between the harness connector terminal of integrated module and chassis ground when moving the door lock switch to LOCK. Connector & terminal (B281) No. 6 (+) - Chassis ground (-): |
Is the measured value more than 10 V? | Go to step 2. | Replace the integrated module. |
| 2 CHECK OUTPUT SIGNAL. Measure the voltage between the harness connector terminal of integrated module and chassis ground when moving the door lock switch to UNLOCK. Connector & terminal (B281) No. 7, 8 (+) - Chassis ground (-): |
Is the measured value more than 10 V? | Go to step 3. | Replace the integrated module. |
| 3 CHECK DOOR LOCK ACTUATOR. Check the door lock actuator. Front door lock actuator: < Ref. to FRONT DOOR LOCK ACTUATOR . > Rear door lock actuator: < Ref. to REAR DOOR LOCK ACTUATOR . > |
Is the door lock actuator OK? | Check the harness for open circuits or shorts between the integrated module and the door lock actuator. | Replace the door lock actuator. |