General Scan Tool
- After clearing the memory, check for any remaining unresolved trouble data.
<Ref. to CLEAR MEMORY MODE . >
- Warm up the engine.
- Connect the test mode connector (A) at the lower portion of instrument panel (on the driver's side).
- Connect the general scan tool to its data link connector.CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
- Start the engine.NOTE:
- Ensure the selector lever is placed in "P" range before starting. (AT model)
- Depress the clutch pedal when starting engine. (MT model)
- Using the selector lever or shift lever, turn the "P" position switch and "N" position switch to ON.
- Depress the brake pedal to turn the brake switch ON. (AT model)
- Keep the engine speed in 2,500 - 3,000 rpm range for 40 seconds.
- Place the selector lever or shift lever in "D" range (AT model) or "1st" gear (MT model) and drive the vehicle at 5 to 10 km/h (3 to 6 MPH).NOTE:
- For AWD model, release the parking brake.
- The speed difference between front and rear wheels may light the ABS warning light, but this indicates no malfunctions. When engine control diagnosis is finished, perform the ABS memory clearance procedure of self-diagnosis system.
- Using the general scan tool, check DTC and record the result(s).NOTE:
- For detailed operation procedures, refer to the General Scan Tool Instruction Manual.
- For details concerning DTC, refer to " LIST OF DIAGNOSTIC TROUBLE CODE (DTC) ".