System Operation Check Mode: Operation: Notes

Prepare the Subaru Select Monitor kit. <Ref. to PREPARATION TOOL , General Description. >
Connect the diagnosis cable to the Subaru Select Monitor.
Connect the Subaru Select Monitor to data link connector located in the lower portion of the instrument panel (on the driver's side).

Fig 1: Identifying Data Link Connector Location
Courtesy of SUBARU OF AMERICA, INC.

CAUTION: Do not connect scan tools except for Subaru Select Monitor and general scan tool.
Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
On the «Main Menu» display screen, select the {Each System Check}.
On the «System Selection Menu» display screen, select the {Engine Control System}.
Select the [OK] after the information of engine type has been displayed.
On the «Engine Diagnosis» display screen, select the {System Operation Check Mode}.

The following items are displayed on the monitor.

MONITOR INFORMATIONS

Display
Fuel Pump Control
Idling Ignition Timing Fixed
Idle Speed Control
Injector Control
EGR Valve Control