When The Si-Drive Mode Is Changed, "Mode Change Error" Appears In The Multi-Information Display Approximately 5 Seconds Later

DIAGNOSTIC PROCEDURE CHART

Step	Check	Yes	No
1 CHECK DTC.	Is DTC displayed?	Check for the corresponding DTC using the "List of Diagnostic Trouble Code (DTC)" for each unit.	Go to step 2.
2 CHECK DISPLAY OF MULTI-INFORMATION DISPLAY METER. Check whether there are other errors displayed other than the "Mode Change Error". Example: "Err" is displayed in the external temperature or fuel consumption displays. FUEL gauge, TEMP gauge or ECO gauge does not move.	Is there other errors displayed other than the "Mode Change Error"?	For the diagnostic procedure, refer to LAN section. <Ref. to BASIC DIAGNOSTIC PROCEDURE . >	Go to step 3.
3 CHECK MULTI-INFORMATION DISPLAY METER AND ECM.	Is the multi-information display meter and ECM part numbers correct?	Replace the multi-information display meter. <Ref. to COMBINATION METER . >	Replace the multi-information display meter and/or ECM to that of the correct part number. <Ref. to COMBINATION METER . > or <Ref. to ENGINE CONTROL MODULE (ECM) . >