LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2007 >> Outback XT Limited, Automatic >> Repair and Diagnosis >> Transmission >> Clutch System >> Operating Cylinder >> Removal
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Operating Cylinder: Removal

  1. Remove the air intake chamber. (Non-turbo model) <Ref. to REMOVAL , Air Intake Chamber .>
  2. Remove the intercooler. (Turbo model) <Ref. to REMOVAL , Intercooler .>
  3. Disconnect the clutch hose from the operating cylinder.
    CAUTION:
    • Cover the hose joint to prevent the clutch fluid from flowing out.
    • Do not loosen or remove the cap bolts. (5MT turbo model)
    • 5MT model
      NOTE: The illustration below is for a Non-turbo model. However, perform the same procedures for the Turbo model.
      Fig 1: Identifying Operating Cylinder And Clutch Hose (Non-Turbo Model)
      G05342752Courtesy of SUBARU OF AMERICA, INC.
    • 6MT model
      Fig 2: Identifying Operating Cylinder, Clutch Hose And Cab Bolt (6MT Model)
      G05342753Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the operating cylinder from the transmission.
    • 5MT model
      NOTE: The illustration below is for a Non-turbo model. However, perform the same procedures for the Turbo model.
      Fig 3: Locating Operating Cylinder Bolts (Non-Turbo Model)
      G05342754Courtesy of SUBARU OF AMERICA, INC.
    • 6MT model
      Fig 4: Locating Operating Cylinder Bolts (6MT Model)
      G05342755Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals