SUBARU Select Monitor

After clearing the memory, check for any remaining unresolved trouble data. <Ref. to CLEAR MEMORY MODE . >
Warm-up the engine.
Prepare the Subaru Select Monitor kit. <Ref. to PREPARATION TOOL , General Description .>
Connect the diagnosis cable to the Subaru Select Monitor.
Connect the test mode connector (A) located under the glove box.

Fig 1: Identifying Test Mode Connector
Courtesy of SUBARU OF AMERICA, INC.
Connect the Subaru Select Monitor to data link connector located in the lower portion of the instrument panel (on the driver's side).
CAUTION: Do not connect any scan tools except the Subaru Select Monitor or general scan tool.

Fig 2: Locating Data Link Connector Location
Courtesy of SUBARU OF AMERICA, INC.
Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
On the «Main Menu» display screen, select {Each System Check}.
On the «System Selection Menu» display screen, select {Engine Control System}.
Select the [OK] after the information of engine type has been displayed.
On the «Engine Diagnosis» display screen, select {D Check}.
When the "Perform Inspection (Dealer Check) Mode" is shown on the screen, select the [OK].
Perform subsequent procedures as instructed on the display screen.
- If trouble still remains in the memory, the corresponding DTC appears on the display screen.
  NOTE:
  - For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
  - For details concerning DTC, refer to "List of Diagnostic Trouble Code (DTC)".
    <Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >
  - Release the parking brake.
  - The speed difference between front and rear wheels may illuminate the ABS warning light, but this does not indicate a malfunction. When engine control diagnosis is finished, perform the ABS memory clearance procedure of the self-diagnosis system. <Ref. to CLEAR MEMORY MODE . >