LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (A/T & M/T Control Systems) >> AT Shift Lock Control System >> Inspection >> Body Integrated Unit Power Supply And Ground Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Body Integrated Unit Power Supply And Ground Circuit

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Body Integrated Unit Power Supply And Ground Circuit Diagram
G05019657
BODY INTEGRATED UNIT POWER SUPPLY DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK DTC OF BODY INTEGRATED UNIT. 
Check DTC of body integrated unit.
< Ref. to OPERATION , Subaru Select Monitor. >		 Is the DTC of power line displayed on body integrated unit? Repair or replace it according to the DTC. Go to step 2  .
2 CHECK HARNESS CONNECTOR BETWEEN BODY INTEGRATED UNIT AND CHASSIS GROUND. 
  1. Turn the ignition switch to OFF.
  2. Measure the harness resistance between the body integrated unit and chassis ground.

    Connector & terminal 

    (i84) No. 21 - Chassis ground: 

    (B280) No. 22 - Chassis ground: 

    (B281) No. 8 - Chassis ground: 

    (B281) No. 9 - Chassis ground: 

 Is the resistance less than 1 ≤ Go to step 3.  Repair the open circuit of harness between the body integrated unit and chassis ground.
3 CHECK POOR CONTACT.  Is there poor contact in connector? Repair the poor contact. Check the body integrated unit.
scientia non olet · About LEMON Manuals