VDC Control Module and Hydraulic Control Unit (VDCCM&H/U): Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the VDCCM&H/U bracket.
Tightening torque:

33 N.m (3.3 kgf-m, 24 ft-lb)
Install the VDCCM&H/U to the bracket.
Install the clip.

Fig 1: Identifying VDCCM&H/U Clip

NOTE: Hook the clip on the claw of the bracket securely.
Connect the brake pipes to their correct VDCCM&H/U positions.
Tightening torque:

< Ref. to FRONT BRAKE PIPES AND HOSE , COMPONENT, General Description. >
Connect the VDCCM&H/U connector.
NOTE:
- Be sure to remove all foreign matter from inside the connector before connecting.
- Make sure the VDCCM&H/U connector is securely locked.
Connect the pressure sensor connector.
Bleed air from the brake system.