Display Of Status Information

WARNING: This page is about a different car, the 2006 Subaru Outback, 2006 Subaru Legacy, and 2006 Saab 9-2X. However, it is still accessible from the selected car via links, so may be relevant.

Check the operating condition of each sensor in the event of a malfunction in the seat belt buckle switch and seat position sensor, or when the seat belt buckle switch and seat position sensor have been replaced.

On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
On the «System Selection Menu» display screen, select the {Airbag System} and press the [YES] key.

On the «Airbag System» display screen, select the {Status Data} and press the [YES] key.

The following table is for support data.

DISPLAY CONTENTS

Contents

Display Contents

Seat position sensor LH

Front position ⁽¹⁾/Rear position ⁽²⁾ /Other ⁽³⁾/Initial Setting ⁽³⁾ /- ⁽⁵⁾

Seat position sensor RH

- ⁽⁵⁾

Seat belt buckle switch LH

Buckled ⁽⁶⁾/Unbuckled ⁽⁷⁾ /Other ⁽⁸⁾/Initial Setting ⁽⁴⁾ /- ⁽⁹⁾

Seat belt buckle switch RH

Buckled ⁽⁶⁾/Unbuckled ⁽⁷⁾ /Other ⁽⁸⁾/Initial Setting ⁽⁴⁾ /- ⁽⁹⁾

Passenger's airbag control status

ON ⁽¹⁰⁾/OFF ⁽¹¹⁾ /Initial Setting ⁽⁴⁾

⁽¹⁾	The seat position is forward.

⁽²⁾	The seat position is rearward.

⁽³⁾	Displayed when data other than before and behind the seat, such as the breakdown etc, is input.

⁽⁴⁾	Displayed in the initial condition.

⁽⁵⁾	Seat position sensor not supported

⁽⁶⁾	Seat belt fastened

⁽⁷⁾	Seat belt not fastened

⁽⁸⁾	Displayed when data other than belt fastened / not fastened is entered.(Such as fault data etc.)

⁽⁹⁾	Seat belt buckle switch not supported

⁽¹⁰⁾	Passenger's seat airbag operation status

⁽¹¹⁾	Passenger's seat airbag non-operation status

NOTE: For details concerning the operation procedures, refer to the "Subaru Select Monitor Operation Manual".