LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Tribeca Base >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transmission (Diagnostics) (5AT) >> Learning Control >> Procedure >> Preparation For Learning Control
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Preparation For Learning Control

  1. Shift the select lever to "P" range, and turn the ignition switch to ON (Engine OFF).
  2. Read DTC using Subaru Select Monitor to confirm no DTC is detected. <Ref. to READ DIAGNOSTIC TROUBLE CODE (DTC) , OPERATION, Subaru Select Monitor.>
  3. Start the engine.
  4. Drive the vehicle until ATF oil temperature displayed by the current data read operation on Subaru Select Monitor reaches 60 - 90°C (140 - 194°F). <Ref. to READ CURRENT DATA , OPERATION, Subaru Select Monitor.>
  5. Lift up the vehicle.
    CAUTION: When performing learning control, be sure to keep the lower edge of the tires 30 cm or more above the ground as vehicle vibrates during the work.
  6. Shift the select lever to "P" range, and turn the ignition switch to OFF.
  7. Fully apply the parking brake.
    CAUTION: When performing the transfer clutch learning, fully apply the parking brake to avoid tires from rotating.
scientia non olet · About LEMON Manuals