LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2009 >> Outback Limited >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H4SO) >> Basic Diagnostic Procedure >> Procedure >> Engine
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Basic Diagnostic Procedure: Procedure: Engine

ENGINE DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK ENGINE START FAILURE. 
  1. Ask the customer when and how the trouble occurred using the interview checklist. Refer to CHECK , Check List for Interview.
  2. Start the engine.
 Does the engine start? Go to step 2.  Inspection using Diagnostics for Engine Start Failure. Refer to DIAGNOSTICS FOR ENGINE STARTING FAILURE .
2 CHECK ILLUMINATION OF MALFUNCTION INDICATOR LIGHT.  Does the malfunction indicator light illuminate? Go to step 3.  Inspection using "General Diagnostic Table" Refer to INSPECTION , General Diagnostic Table.
3 CHECK THE COMMUNICATION STATUS. 
  1. Turn the ignition switch to OFF.
  2. Conned the Subaru Select Monitor or general scan tool to the data link connector.
  3. Turn the ignition switch to ON, and run the Subaru Select Monitor or general scan tool.
NOTE:
  • SUBARU SELECT MONITOR

    For detailed procedures, refer to SUBARU SELECT MONITOR .

  • General Scan Tool

    For detailed operation procedures, refer to the general scan tool operation manual.

 Does Subaru select monitor or general scan tool communicate with vehicle normally? Go to step 4.  Inspection using "Diagnostics Procedure for Subaru Select Monitor Communication". Refer to DIAGNOSTIC PROCEDURE FOR SUBARU SELECT MONITOR COMMUNICATION .
4 CHECK DTC. 
Read DTC using Subaru Select Monitor or general scan tool.
NOTE:
  • SUBARU SELECT MONITOR

    Refer to READ DIAGNOSTIC TROUBLE CODE (DTC)  for detailed operation procedure.

  • General Scan Tool

    For detailed operation procedures, refer to the general scan tool operation manual.

 Is DTC displayed on the Subaru Select Monitor or general scan tool? Record the DTC. Repair the trouble cause. Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .
Go to step 5. 		 Repair the related parts.
NOTE: If DTC is not shown on display although the malfunction indicator light illuminates, perform the diagnosis of malfunction indicator light circuit or combination meter. Refer to MALFUNCTION INDICATOR LIGHT .
5 PERFORM DIAGNOSIS. 
  1. Perform the Clear Memory Mode. Refer to CLEAR MEMORY MODE .
  2. Perform the Inspection Mode. Refer to INSPECTION MODE .
 Is DTC displayed on the Subaru Select Monitor or general scan tool? Inspect using "Diagnostic Procedure with Diagnostic Trouble Code (DTC)"Refer to DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC) . Finish the diagnosis.
scientia non olet · About LEMON Manuals