General Scan Tool
- After performing the diagnostics and clearing the memory, check that no DTC remains. Refer to CLEAR MEMORY MODE .
- Warm up the engine.
- Connect the delivery (test) mode connector (A) located under the glove box.
- Connect the general scan tool to the data link connector located in the lower portion of the instrument panel (on the driver' side).CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
- Start the engine.NOTE:
- Ensure the selector lever is placed in "P" range before starting. (AT model)
- Depress the clutch pedal when starting engine. (MT model)
- Turn the neutral position switch to ON using select lever or shift lever.
- Depress the brake pedal to turn the brake switch ON. (AT model)
- Keep the engine speed in 2,500 - 3,000 RPM range for 40 seconds.
- Place the select lever or shift lever in D position (AT model) or 1st gear (MT model) and drive the vehicle at 5 to 10 km/h (3 to 6 MPH).NOTE:
- For AWD model, release the parking brake.
- The speed difference between front and rear wheels may light the ABS warning light, but this indicates no malfunctions. When engine control diagnosis is finished, perform the ABS memory clearance procedure of self-diagnosis system.
Refer to CLEAR MEMORY MODE .
- Using the general scan tool, check DTC and record the result(s).NOTE:
- For detailed operation procedures, refer to the general scan tool operation manual.
- For details concerning DTC, refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .