Simple Learning
NOTE:
Simple learning is performed with the vehicle lifted, without actually running the vehicle.
CAUTION:
Do not turn the power of the Subaru Select Monitor to OFF or disconnect the data link connector during the operation.
- Select {AT related learning & inspecting mode} in the «Transmission Diagnosis» screen of the Subaru Select Monitor.
- Select {AT learning mode} in the «AT related learning & inspecting mode» screen of the Subaru Select Monitor.
- Follow the messages displayed on the Subaru Select Monitor screen when working.NOTE: During AT learning in progress, AT OIL TEMP light in the combination meter starts flashing at 2 Hz and the learning operation starts. The following message is displayed on the screen when the AT OIL TEMP light which was flashing at 2 Hz turns off.
- "AT learning normally ended." is displayed, simple AT learning is completed.
NOTE:
- If communication error occurs during learning, retry the "AT learning mode" from the beginning.
- If the message "Execute AT learning again after fixing troubles of the vehicle" is displayed during learning, select [OK] to display the List of Diagnostics Trouble Code. After repairing the locations indicated by the DTC, start the "AT learning mode" over from the beginning.
- When communication error occurs during learning, select lever does not shift occasionally. If select lever does not shift, turn the ignition to OFF and operate the lever.
If the message "AT learning ended abnormally." is displayed, start the "AT learning mode" over from the beginning.
AT LEARNING MODE REFERENCE
| Message | Primary cause of abnormal end |
|---|---|
| AT learning ended abnormally. |
|
- For detailed operation procedures, refer to PC application help for Subaru Select Monitor.