Torque Converter Assembly: Installation
WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Install the O-ring to front reduction drive gear.NOTE:
- Use new O-rings.
- Apply CVTF to the O-ring.
- While holding the torque converter assembly by hand, carefully install it into the torque converter case.NOTE:
- Apply CVTF to the oil seal lip.
- Do not damage the oil seal and O-ring.
- Engage the splines while gently rotating the torque converter assembly by hand, and securely insert the assembly.
- Measure depth "A", from converter case end surface to drive plate contacting surface.
Standard (A) (reference):
6.8 mm (0.268 in)
- Install the transmission assembly to the vehicle. Refer to , INSTALLATION , Automatic Transmission Assembly.