LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2011 >> Outback R >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> Fuel Injection Fuel Systems (H6DO) >> Engine Coolant Temperature Sensor >> Removal
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Engine Coolant Temperature Sensor: Removal

  1. Remove the collector cover.
    NOTE: Follow these procedures for removal of the collector cover.
    1. Lift up the rear side holding two positions (A).
    2. Lift up the front side holding two positions (B) while moving it in the forward direction of the vehicle.
      Fig 1: Removing Collector Cover
      G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the ground cable from battery.
  3. Drain engine coolant. Refer to ENGINE COOLANT .
  4. Disconnect the connectors from the engine coolant temperature sensor.
    Fig 2: Identifying Engine Coolant Temperature Sensor Connectors
    G06651227Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the engine coolant temperature sensor.
scientia non olet · About LEMON Manuals