Select Lever: Assembly

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Clean all the parts before assembly.
Apply Multemp D or equivalent to each part.
Assemble in the reverse order of disassembly.
NOTE: Insert the solenoid unit terminals to the harness connector.

Fig 1: Inserting Solenoid Unit Terminals To Harness Connector
Courtesy of SUBARU OF AMERICA, INC.
After installation, check the following points.

The select indicator matches the select lever position when the select lever is changed from "P" range to "D" range.
The select lever position and the position mark match each other.
Operating force to move the select lever from "P" to "D" range.