DTC 2A ODS Calibration Error: DTC Detecting Condition
WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Calibration of occupant detection control module is initial setting or faulty.
- Occupant detection control module is faulty.
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK DTC. Read the DTC of the airbag system using the Subaru Select Monitor. |
Is DTC other than 2A displayed? | Perform the diagnosis according to the displayed DTC. | Go to step 2. |
| 2 PERFORM RE-ZEROING. Perform system calibration using the Subaru Select Monitor. Refer to , SYSTEM CALIBRATION (REZEROING) . |
Did the system calibration complete properly? | Go to step 3. | Replace the occupant detection system. Refer to FRONT SEAT . |
3 CHECK DTC.
|
Is DTC other than DTC 2A displayed? | Perform the diagnosis according to the displayed DTC. | When DTC is 2A, replace the occupant detection system. Refer to FRONT SEAT . When DTC is not displayed, end the diagnosis. |
CAUTION:
When DTC other than DTC 2A is present, system calibration (re-zeroing) cannot be completed normally.
When occupant detection system DTC other than DTC 2A is present (27, 29, 2B, 37), perform the diagnosis of the DTCs other than 2A first.
When occupant detection system DTC other than DTC 2A is present (27, 29, 2B, 37), perform the diagnosis of the DTCs other than 2A first.