User Customizing: Operation
- On << Main Menu >> display, select {Each System Check}.
- On << System Selection Menu >> display, select {Integ. unit mode}.
- On << Integ. unit mode failure diag.> display, select {Integ. Unit customizing}.
- Change the setting with UP/DOWN key and set with the [OK] key.
List of User Customizing item
Data Initial setting value Customize setting Remarks Off delay time Long Delay time below can be selected by setting. OFF 0 seconds Short 10 seconds Normal 20 seconds Long 30 seconds Auto Light Sensitivity Adjustment 3rd 1st Slow response 2nd Standard 3rd Quick response 4th Fairly quick response Rr Defogger op. mode Normal Normal Automatically stops in 15 minutes after switch is turned to ON. Continuous Repeats active condition for 15 minutes and inactive condition for 2 minutes until switch is turned to OFF. Security Alarm Setup ON ON Security alarm (hazard, horn or siren) in active condition OFF Security alarm in inactive condition Impact Sensor Setup OFF ON Workable when Impact Sensor Setup is set to "ON" Impact sensor function becomes activated. OFF Impact sensor in inactive condition (Set to "OFF" in models without sensors.) Alarm delay setup ON After the keyless lock operation, the alarm monitor starts after the following delay time has passed. ON Delay time is 30 seconds. OFF Delay time is 0 seconds. Lockout prevention ON ON Lockout prevention in active condition. (The function does not operate if safety knob is locked by hand.) OFF Lockout prevention in inactive condition Impact sensor (OP) OFF ON Vehicle is controlled in impact sensor equipped mode. (Make sure to set to "OFF" for models without the impact sensor. When "ON", hazard, horn or siren become activated by keyless lock (alarm monitor start). OFF Vehicle is controlled in no impact sensor mode. Answer-back buzzer setup ON ON When lock/unlock is selected by keyless entry system operation, buzzer operates. OFF When lock/unlock is selected by keyless entry system operation, buzzer does not operate. Hazard answer-back setup ON ON When lock/unlock is selected by keyless entry system operation, hazard blinks. OFF When lock/unlock is selected by keyless entry system operation, hazard does not interlock. Initial keyless setting - - Execution Initial button setting - - Execution Passive Alarm OFF ON OFF Door open warning ON ON OFF Dome Light Alarm Setting OFF ON Room light illuminates interlocking with alarm. OFF Room light does not illuminate interlocking with alarm. Belt Warning Switch ON ON Belt warning buzzer beeps. OFF Belt warning buzzer stops. Auto A/C ECU Setting - ON Diagnoses with auto A/C ECU. OFF Diagnoses without auto A/C ECU. Line Navigation Setting - ON Diagnoses with line navigation. OFF Diagnoses without line navigation. wiperdeicer - ON Wiper deicer control is performed. OFF Wiper deicer control is not performed. Sedan/Wagon Setting - Sedan Body control is performed by Sedan. Wagon Body control is performed by Wagon. MT/AT Setting - MT Body control is performed by MT. AT Body control is performed by AT. 6MT Setting - 6MT Body control is performed by 6MT. Other than 6MT Body control is performed by other than 6MT. Factory initial setting Market Market Customize setting is reset when mode is switched from Factory Market to Factory. Factory. - After setting, make sure that the setting changed in the {Current Data Display & Save} is same as vehicle equipment.CAUTION:
- The above settings must match the actual vehicle equipment.
- Do not change settings except for setting above while setting the functions.
- Be sure not to change Factory initial setting except when installing a new body integrated unit.
NOTE: For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".