Data Display
WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
- On «Main Menu» display, select {Each System Check}.
- On «System Selection Menu» display, select {Tire pressure monitor}.
- After the {Tire pressure monitor} is displayed, select [OK].
- On «Tire pressure monitor diagnosis» display, select {Data Display}, and then necessary data will be displayed.
- A list of the support data is shown in the following table.
| Display | Contents to be displayed | Unit of measure |
|---|---|---|
| Tire 1 FN code | LEARN, LOW BAT, OFF, WAKE, RE ME, NORMAL | LEARN: Transmitted transmitter ID using the transmitter registration tool LOW BAT: Transmitter battery voltage running low OFF: Transmitter function stops (no data transmission) RE ME: Tire air changes ±8.4 kPa WAKE: When data transmission is started from a stopped state. NORMAL: Conditions other than above |
| Tire 2 FN code | ||
| Tire 3 FN code | ||
| Tire 4 FN code | ||
| Tire 1 air pressure | Value converted to tire pressure from data delivered from transmitter is displayed. (The figure may differ from the actual measured values.) |
kPa, psig, mmHg, inHg |
| Tire 2 air pressure | kPa, psig, mmHg, inHg | |
| Tire 3 air pressure | kPa, psig, mmHg, inHg | |
| Tire 4 air pressure | kPa, psig, mmHg, inHg | |
| Vehicle Speed | Vehicle speed signal which is input in control module | km/h, MPH |
| Pressure warning | Threshold where tire pressure warning light illuminates | kPa, psig, mmHg, inHg |
| Return pressure | Threshold where tire pressure warning light goes out | kPa, psig, mmHg, inHg |