Simple Learning

NOTE: Simple learning is performed with the vehicle lifted, without actually running the vehicle.

CAUTION: Do not turn the power of the Subaru Select Monitor OFF during work, and do not disconnect the datalink connector.

Select {AT related learning & inspecting mode} in the «Transmission Diagnosis» display screen of the Subaru Select Monitor.
Select {AT learning mode} in the «AT related learning & inspecting mode» screen of the Subaru Select Monitor.
Follow the messages displayed on the Subaru Select Monitor screen when working.
NOTE: For the messages "SHIFT control system learning in progress" and "AWD control system learning in progress", AT OIL TEMP light in the combination meter blinks at a cycle of 2 Hz before learning operation starts. When AT OIL TEMP light in the combination meter goes off, the following message is displayed on the screen. When operation ends abnormally during the learning, AT OIL TEMP light blinks at a cycle of 4 Hz.

When «AT learning normally ended.» is displayed, simple AT learning is completed.

NOTE:

If communication error occurs during learning, retry the "AT learning mode" from the beginning.
If the message «Execute AT learning again after fixing troubles of the vehicle» is displayed during learning, select [OK] to display the List of Diagnostics Trouble Code. After repairing the locations indicated by the DTC, start the "AT learning mode" over from the beginning.

If the message «AT learning ended abnormally.» is displayed, start the "AT learning mode" over from the beginning.

Message	Main reasons for abnormal termination
«AT learning ended abnormally.»	Fault is detected during AT learning. The accelerator pedal is depressed during AT learning. An unspecified operation was performed during AT learning Brake pedal is not fully depressed. Electric parking brake not applied strongly enough Abnormal idle speed increase, etc.

For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".