LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2013 >> Tribeca >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls (Diagnostics) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P2127 Throttle/Pedal Position Sensor/Switch "E" Circuit Low Input >> Diagnostic Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedure

DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK HARNESS BETWEEN ECM AND ACCELERATOR PEDAL POSITION SENSOR CONNECTOR. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the connectors from ECM and accelerator pedal position sensor.
  3. Measure the resistance between ECM and chassis ground.

    Connector & terminal 

    (B135) No. 22 - Chassis ground: 

    (B135) No. 31 - Chassis ground: 

 Is the resistance 1 MΩ or more? Go to step 2  . Repair the short circuit to ground in harness between ECM and accelerator pedal position sensor connector.
2 CHECK SHORT CIRCUIT INSIDE THE ECM. 
  1. Connect the connector to ECM.
  2. Measure the resistance between accelerator pedal position sensor connector and chassis ground.

    Connector & terminal 

    (B315) No. 3 - Chassis ground: 

 Is the resistance 1 MΩ or more? Replace the accelerator pedal. Refer to ACCELERATOR PEDAL . > Repair the short circuit to ground in harness between ECM and accelerator pedal position sensor connector. Replace the ECM if defective. Refer to ENGINE CONTROL MODULE (ECM) . >
scientia non olet · About LEMON Manuals