LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> BRZ Series.Blue, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Intake System / Exhaust System) >> Intake Manifold Assembly (FA20) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Intake Manifold Assembly (FA20): Installation

WARNING: This page is about a different car, the 2014 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL INTAKE MANIFOLD
    1. Install the 2 new gaskets to the intake manifold.
    2. Install the intake manifold with the 6 bolts.

      Standard value: T=25N.m {255kgf.cm} {18.4ft.lbf}

    3. Engage the 2 clamps.
    4. Engage the 4 connectors and connect the wire harness.
    5. Connect the fuel pump connector.
    6. Engage the clamp and connect the engine wire harness.
    7. Engage the 5 clamps and connect the battery cable.
    8. Connect the purge control solenoid valve connector.
    9. Connect the manifold absolute pressure sensor connector.
  2. CONNECT VENTILATION HOSE
    1. Connect the ventilation hose.
  3. CONNECT NO. 2 VACUUM HOSE (for Manual Transmission) (Refer to INSTALLATION )
  4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
    1. Engage the 3 claws and install the No. 1 engine cover sub-assembly.
  5. CONNECT FUEL DELIVERY PIPE SUB-ASSEMBLY
    1. Connect the No. 2 fuel vapor feed hose.
    2. Install the bolt and connect the fuel delivery pipe sub-assembly.

      Standard value: T=6.4N.m {65kgf.cm} {4.7ft.lbf}

  6. INSTALL INTAKE MANIFOLD PROTECTOR (for Bank 2) (Refer to UNIT INSPECTION )
  7. INSTALL INTAKE MANIFOLD PROTECTOR (for Bank 1) (Refer to UNIT INSPECTION )
  8. INSTALL INJECTOR DRIVER (Refer to INSTALLATION )
  9. CONNECT PURGE HOSE (Refer to UNIT INSPECTION )
  10. CONNECT FUEL HOSE NO. 2 (Refer to UNIT INSPECTION )
  11. CONNECT FUEL HOSE NO. 1 (Refer to UNIT INSPECTION )
  12. CONNECT THROTTLE WITH MOTOR BODY ASSEMBLY
    1. Install a new gasket to the intake manifold.
    2. Install the 4 bolts and throttle with motor body assembly to intake manifold.

      Standard value: T=8.0N.m {82kgf.cm} {5.9ft.lbf}

  13. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE (Refer to FUEL SYSTEM (FA20) )
  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}

  15. INSPECT FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK (Refer to PARTS LOCATION )
  16. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY (Refer to UNIT INSPECTION )
scientia non olet · About LEMON Manuals