Throttle Body Assembly (FA20): Installation
WARNING: This page is about a different car, the 2014 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.
- Installation of throttle body assembly (with motor)
- Use a new throttle body gasket, install the throttle body assembly (with motor) to the intake manifold with 4 bolts.
Standard value: T=8.0N.m {82kgf.cm} {5.9 ft.lbf}
- Using 2 clamps, connect the water bypass hose No. 2 and water bypass hose No. 3 to the throttle body assembly (with motor).
- Connect the connector for the throttle body assembly (with motor).
- Use a new throttle body gasket, install the throttle body assembly (with motor) to the intake manifold with 4 bolts.
- Installation of air cleaner case sub-assembly (Refer to INSTALLATION )
- Connection of battery ground terminal
Standard value: T=6.0N.m {61kgf.cm} {4.4 ft.lbf}
- Replenishing of coolant (SUBARU Super Coolant) (Refer to COOLANT (FA20) )
- Leak check of coolant (SUBARU Super Coolant) (Refer to COOLING SYSTEM (FA20) )
- Function inspection of throttle body assembly (with motor) (Refer to ON-VEHICLE INSPECTION )