VDCCM Parameter Selection

CAUTION:

NOTE:

When the VDCCM&H/U is replaced with a replacement part, be sure to perform the parameter selection/registration to the VDCCM&H/U using this function.
To check the applied model, refer to the "Model number plate" attached to the vehicle. <Ref. to IDENTIFICATION , Identification.>
If you entered a wrong applied model, you can re-write it.
When the registration has not been performed, the DTC code "Parameter" is detected together with the ABS/EBD/VDC warning light illumination.

Connect the Subaru Select Monitor.
On «Main Menu» display, select «Each System Check».
On «System Selection Menu» display, select «Brake Control System».
On «Brake Control System» display, select «ABS/VDC System».
When «VDC/parking brake» is displayed, select the [OK] button.
On «Brake Control Diagnosis» display, select «Work Support».
On «Work Support» display, select «Maintenance at the time of ECM replacement».
Select «Selection of Parameter».
Check the applied model and option code indicated on the "Model number plate". <Ref. to IDENTIFICATION , Identification.>
Enter the applied model of 7-digit alphanumeric characters and press the [Enter] key.
When the option code input screen appears after entering the applied model, enter the option code consisting of 4-digit alphanumeric characters, and press the [Enter] key. When the option code is 3 digits, add "0" (zero) in front and enter the code as 4 digits.
When the confirmation screen indicating the vehicle information appears, check that the correct applied model and grade are displayed and click the [OK] button.
NOTE: When the displayed applied model and grade are different from those of the vehicle, perform registration operations again after clicking the [OK] button.
Execute the Clear Memory Mode after parameter selection and registration operations because the DTC for "Parameter selection error" is memorized. <Ref. to CLEAR MEMORY MODE .>