Security Control Module: Removal
CAUTION:
- Before handling the airbag module, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". <Ref. to CAUTION , General Description.>
- Do not allow harness and connectors to interfere or get tangled up with other parts.
- If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VDC sensor midpoint setting mode" of the VDC. <Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).>
- Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. <Ref. to
BATTERY
, NOTE, Note.>NOTE: For models other than STI model, disconnect the ground terminal from battery sensor.
- Remove the instrument panel assembly. <Ref. to REMOVAL , Instrument Panel Assembly.>
- Remove the heater and cooling unit assembly. <Ref. to REMOVAL , Heater and Cooling Unit.>
- Remove the security control module.
- Disconnect the connector.
- Remove the nuts, and remove the security control module.