Steering Lock Control Module: Installation
CAUTION:
- Registration of the immobilizer is necessary when a immobilizer-related control module has been replaced. For the relevant procedures, refer to the "REGISTRATION MANUAL FOR IMMOBILIZER".
- Before handling the airbag module, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". <Ref. to CAUTION , General Description.>
- Do not allow harness and connectors to interfere or get tangled up with other parts.
- If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VDC sensor midpoint setting mode" of the VDC. <Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).>
- Secure the steering lock control module to the steering column.
- Use new set bolts. Tighten the bolt until the bolt head is broken (bolt head wrenched off).
- Install the column assembly - steering.
- Connect the battery ground terminal. <Ref. to BATTERY , NOTE, Note.>
NOTE:
For models other than STI model, connect the ground terminal to battery sensor.